Xantrex MS2000 Bedienungsanleitung Seite 106
- Seite / 126
- Inhaltsverzeichnis
- FEHLERBEHEBUNG
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
Battery Charging Reference for the Main Charger
B–2 975-0125-02-01
Charging Algorithms (Formulas)
Battery Type
MS2000 charges flooded (or wet) lead-acid, gel, AGM (absorbed glass mat), and
custom batteries.
Flooded (or wet) Flooded (or wet) batteries have removable battery caps for refilling with distilled
water and testing the electrolyte.
Gel Gel batteries have the electrolyte in the form of a gel rather than a liquid and do
not require topping up. Gel batteries are sealed and the battery caps are not
removable.
AGM AGM (absorbed glass mat) batteries are similar to gel batteries except that the
electrolyte is absorbed into a fiberglass matting.
Custom Custom is configured by the dealer, factory, or service center for battery types
other than those listed above.
Charge Algorithm Stages
Three-stage charging
If three-stage charging is enabled, the MS2000 will charge batteries in a sequence
known as three-stage charging. The charging voltage delivered to the battery
depends on the battery:
• type setting
• temperature (by switch setting or battery temperature sensor)
• state of charge
The three automatic stages are:
• bulk
• absorption
• float
See Figure B-1 for a graph of the three-stage charging profile.
There is a fourth stage, equalization, which is initialized manually as it is only
performed occasionally and only on flooded (or wet) batteries.
WARNING: Risk of battery damage
Since the MS2000 has only one battery type setting for all batteries connected to
its bank, do not mix battery types. All connected batteries should be of one kind:
Flooded (or wet) or Gel or AGM or Custom.
- Operation Guide 1
- About This Guide 5
- Conventions Used 6
- Symbols Used 6
- Related Information 7
- Contact Information 7
- Important Safety Instructions 9
- Explosive Gas Precautions 11
- FCC Information to the User 12
- Contents 13
- Configuration 14
- Troubleshooting 15
- 975-0125-02-01 xv 17
- Introduction 19
- Premium Power and Ease of Use 20
- How MS2000 Works 21
- 1–4 975-0125-02-01 22
- Xanbus System 23
- Xanbus Enabled 23
- MS2000 Features 25
- Figure 1-3 26
- Table 1-2 26
- Side Panel Features 27
- CAUTION: Equipment Damage 27
- Figure 1-5 28
- DC Grounding Completed 28
- DC Terminal Covers 29
- Battery Temperature Sensor 29
- Operation 31
- Important: 32
- On Start Up 34
- Power On Reset 34
- System Start-up Check 35
- System Modes 36
- Operate Mode 37
- Power Save Mode 37
- Safe Mode 38
- CAUTION: Unexpected behavior 38
- 975-0125-02-01 2–9 39
- Hibernate mode 40
- 975-0125-02-01 2–11 41
- Operating in Invert Mode 42
- Power Output 43
- Operating in Charger Mode 44
- Echo Charger Operation 45
- 2–16 975-0125-02-01 46
- WARNING: Explosive gases 48
- Equalizing Batteries 49
- Power Share 52
- Faults and Warnings 54
- System Control 56
- System Menu Map 57
- Viewing the System Screen 58
- 975-0125-02-01 3–5 59
- MS2000 Configuration Menus 60
- 975-0125-02-01 3–7 61
- MS2000 Device Menu 62
- AC Input 63
- Echo Chg Out 63
- MS2000 Menu (Basic) 64
- Equalize 66
- 975-0125-02-01 3–13 67
- 3–14 975-0125-02-01 68
- Batt Type 69
- Batt Size 69
- Clear Faults 70
- MS2000 Menu (Advanced) 71
- Max Chg Rate 72
- Echo Chg 72
- Load Sense 73
- View Device Info 73
- Basic Menu 73
- 975-0125-02-01 3–21 75
- Sub-Menus 76
- Sense Interval 77
- # Chg Stages 77
- Eqz Volts 78
- Force Charge 78
- Lo AC Volt 79
- Lo AC Freq 79
- Hi AC Volt 80
- Hi AC Freq 80
- View Fault Log 81
- View Warning Log 81
- View Event Log 81
- Restore Defaults 82
- Warning Types 85
- Troubleshooting Reference 86
- 975-0125-02-01 4–5 87
- Warning Messages 88
- Table 4-3 89
- Fault Messages 91
- Table 4-4 92
- Inverter Applications 97
- Searching 98
- Specifications 99
- Inverter Specifications 100
- Main Charger Specifications 101
- Echo Charger Specifications 102
- Environmental Specifications 103
- Regulatory Approvals 103
- Fan Operation 103
- Charger Mode 104
- Reference for the Main 105
- Battery Charging 105
- Charge Algorithm Stages 106
- Bulk Charge 107
- Absorption Charge 107
- Float Charge 107
- Two-Stage Charging 108
- Charge Algorithm Graph 109
- Charge Algorithm Definitions 109
- AC Reconnect Summary 110
- Terminology 111
- Glossary 112
- Abbreviations 115
- Warranty 117
- Disclaimer 118
- Return Procedure 119
- Out of Warranty Service 119
- Information About Your System 120
- Xantrex Technology Inc 126
Verwandte Produkte und Handbücher für Netzteile und Wechselrichter Xantrex MS2000
(26 Seiten)© 2020, manymanuals.de. Alle Rechte vorbehalten. | 0.048 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern