Xantrex XC2524 Bedienungsanleitung PDF herunterladen (Seite 21)

Preparing for Installation

975-0187-01-01 1–9

Tools and Materials

To mount and connect the XC Series you need the following tools:

• 10 mm wrench or socket for the DC terminals and ground stud

• Phillips screwdriver for securing the AC wiring compartment cover

• power drill

• drill bit for pilot holes for mounting screws

• wire stripper

• manufacturer's recommended crimp tool for any crimp terminals that are being

used

You need the following materials:

• 3 conductor AC input wiring

Use the information in “AC Wiring” on page 1–13 and your local electrical

codes to determine the correct wire and breaker or fuse.

• AC cable strain relief (if the one included is not sufficient for your local

electrical code requirements)

• appropriately sized DC cables for each battery, with suitable connectors at the

battery end

• appropriately sized DC chassis ground (earth) with suitable connectors

• ring terminals to fit 6 mm (1/4 in.) studs at the charger end

• DC fuse and disconnect or circuit breaker for each battery bank

• mounting hardware, 3 mm (#6) corrosion resistant 6 pieces.

• other means to route and secure AC and DC wiring

XC_Charger_Owner.book Page 9 Friday, August 12, 2005 3:23 PM

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 79 80

Keine Kommentare

Xantrex XC2524 Bedienungsanleitung Seite 21