Xantrex XC2524 Bedienungsanleitung PDF herunterladen (Seite 50)

Operation

3–8 975-0187-01-01

Equalizing Flooded Batteries

About Equalizing

The XC Series equalizes only flooded lead-acid or lead-calcium batteries. It does

not equalize sealed lead-acid batteries since they can be damaged by this process.

In the following conditions the remote display will show

and the XC Series will

not enter equalization mode:

• the battery type is set for Gel or AGM

• any battery is not fully charged (all three battery banks must be charged to float

or rest stage before equalization can be activated on any bank)

• there is an active fault on the battery you are trying to charge

Xantrex recommends that you run a normal charge cycle on the batteries before you

equalize them.

WARNING: Explosion hazard

During equalization, the battery generates explosive gases. Follow all the battery safety

precautions listed in this guide. Ventilate the area around the battery thoroughly and ensure

that there are no sources of flame or sparks in the vicinity

CAUTION: Risk of battery damage

The XC Series cannot automatically determine when to stop the equalization of a battery.

You must monitor the battery specific gravity throughout equalization to determine the end

of the equalize cycle. The one hour time-out is intended as a safety feature to require the

user to continually re-activate it as necessary after checking batteries manually, but may not

be sufficiently short to prevent battery damage.

XC_Charger_Owner.book Page 8 Friday, August 12, 2005 3:23 PM

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 79 80

Keine Kommentare

Xantrex XC2524 Bedienungsanleitung Seite 50